ProStart CT-3271 Guía de instalación descargar pdf (Pagina 3)

CT-3271 p.3

Introduction

This Guide contains all information pertinent to the installation. Most (if not all) features are

grouped in the User Guide. Therefore, should you need information on a feature, please refer to

the User Guide.

Included in the Package

Please review the Installation Guide before beginning the installation, particularly the Wiring

Schematic and the Programming Options.

It is very important that you familiarize yourself with the programming and the operation of the

system, even if you have already installed a similar system in the past. There are many great

features that may be overlooked if the manual is not read; this would prevent you from maximizing

the potential of the Module.

Prior to the installation, make sure that all the hardware components required to install the system

are in the box.

The following is a list of components included in the kit:

1- Control unit

1- Parts bag

1- 2 button remote

1- Installation guide

1- Antenna interconnect cable

1- User guide

1- Harness kit

1- Wiring diagram

1- Antenna

Installation Tools

Here is a list of basic tools and supplies you will need to test and install safely.

• Digital Multi Meter (DMM), Computer safe logic probe, Fused jumper wire, Neon 'trouble' light that is

carpet safe, Fender protector, Carpet protector

• Soldering Iron, solder, electrical tape, wire tie straps, split loom, diodes, resistors, relays

• Wire cutters, Wire strippers, Wire crimpers, Needle Nose Pliers

• Sharp knife, Panel poppers, Various Screw drivers

• Socket set, Wrench set, Drill with Drill Bits, Coat hanger (for fishing wires through the fire wall)

Installation Points to Remember

• On vehicles with a manual transmission, always ensure that all door pins are monitored by the remote

starter.

• Make sure that the Parking brake and Door switch contacts work properly.

• When working on a vehicle, always leave a window open.

• Never leave the keys in the car. Leave them on a workbench with a window rolled down.

• If possible, remove courtesy light fuse to prevent battery drain.

• The Programming Assistance Button (a.k.a. PAB): The PAB is mounted on the side of the unit. This

push button mimics the hood-pin switch in order to avoid having to get out of the vehicle and pressing the

hood-pin switch. The PAB will work only when the hood is up.

• Inspect vehicle for any body damage or electrical problems.

• Always solder and tape all connections.

1 2 3 4 5 6 7 8 ... 26 27

Comentarios a estos manuales

Sin comentarios

ProStart CT-3271 Guía de instalación Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Arrancadores remotos ProStart CT-3271