ProStart CT-3271 Guía de instalación descargar pdf (Pagina 22)

p.22 CT-3271

Note2: If the pre-programmed run-time expires or if the user shuts down the engine by remote

control, the vehicle will enter Ready Mode.

Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.

Turbo Mode

Note: Turbo Mode can be activated only if button is programmed as LOCK or UNLOCK

button.

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user

leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it

is shut down by remote control), then shut down the engine.

If the vehicle has an automatic transmission, proceed as follows to set the system to Turbo

Mode:

1. With the engine running, make sure to release the brake pedal and press the or

on the transmitter until the parking lights come ON.

2. Remove the ignition key from the ignition switch.

The engine will continue running.

3. Exit the vehicle and close all doors, hood and trunk.

4. Press the

& simultaneously; this will lock the doors and arm the Starter Kill.

5. The engine will shut down after 60 seconds.

If your vehicle has a manual transmission, Turbo Mode can be activated only if button is

programmed as LOCK or UNLOCK button. Turbo Mode is activated through the same routine as

that used for Ready Mode (page-19); at the last step, the button is pressed.

Note: The vehicle will enter Ready Mode once the engine run time expires.

Constant lock/unlock or horn output

Horn Confirmation:

This output can be programmed to trigger the horn every time the BUTTON is pressed to lock

the doors. When horn confirmation is activated, panic mode is enabled. If horn confirmation is

disabled, panic mode will not be available.

Constant output

Note: Option 2 must be chosen in Mode2/ Function4 to enable “constant output feature”.

Pressing and holding the

button for more than 3 seconds will lock or unlock all doors and will

send a negative pulse to the lock or unlock wire as long as the

button is held down (maximum

of 15 seconds). This negative pulse can be configured to activate certain functionalities such as

rolling up the windows.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27

Sin comentarios

ProStart CT-3271 Guía de instalación Pagina 22