ProStart CT-3271 Guía de instalación descargar pdf (Pagina 21)

CT-3271 p.21

Secure Lock

This feature allows the module to control certain OEM factory alarm systems without requiring the

use of other wires for disarming the OEM alarm. (Namely, this feature is designed for OEM

systems that use the factory lock wire to arm the alarm and the unlock wire to disarm it.)

1) Standard Secure Lock disabled: By default, the unit will send a disarm pulse before IGN,

an arm pulse once the car is remote started and an arm pulse 4 sec after the engine shuts

down.

Note: No lock pulse or unlock pulse is sent at any moment of the remote start sequence.

2) Standard Secure Lock: If this Option is selected,

at remote start, the module will send an

unlock/disarm pulse (disarming the factory Alarm)

before start-up, lock pulse when the

engine is running, and lock/arm pulse 4 seconds after the engine shuts down.

Note: The unit DOES NOT send an arm pulse while the engine is under remote start.

LED Flashing

• Enabled without Starter kill: The LED will only flash if IGN is OFF

• Disabled: LED flashing is disabled at all times.

• Enabled with Starter kill: The LED will only flash when the Starter kill is armed.

Bypass

Remote starters of this series have the ability to work in two way mode (D2D) with Xpresskit

bypass modules. They also offer one way communication with Xpresskit, ADS and Fortin brand

bypass modules.

Note: For Hardware 5.0 and higher there can only be one bypass connected to the unit.

Engine Run Time

If you have a gas engine, your system can be programmed to run the engine for 3, 15, or 25

minutes (15 min default). If you have a diesel engine, it can be programmed to run the engine for 8,

20, or 30 minutes (20 min default).

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors

locked while you stop, for example, at a convenience store or for a short delivery.

This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the

Ignition Switch) while the engine is running.

If your vehicle has an automatic transmission, proceed as follows to set the system to Idle Mode:

1. With the engine running, make sure to release the brake pedal and press the

BUTTON on the transmitter until the parking lights come ON.

2. Remove the ignition key from the ignition switch.

The engine will continue running.

3. Exit the vehicle and close all doors, hood and trunk.

If your vehicle has a manual transmission, Idle Mode can be activated through the same routine

as that used for Ready Mode (page-19); for the last step, the buttons & are pressed

together to lock the doors and leave the engine running.

Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of

the engine run time.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Comentarios a estos manuales

Sin comentarios

ProStart CT-3271 Guía de instalación Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Arrancadores remotos ProStart CT-3271