ProStart CT-3271 Guía de instalación descargar pdf (Pagina 18)

p.18 CT-3271

Optional Time Delay Adjustment in Virtual Tach System

Follow these steps to program crank time adjustment, if needed:

1. Enter programming mode (page-16)  the parking lights will stay on for up to 20

seconds.

2. Before the lights go out, press and hold the brake pedal and press button and

simultaneously  the parking lights will flash 4 times. Do not release the brake pedal.

3. Press button

if you wish to increase the time delay or button if you want to

decrease it. The time delay will be increased or decreased by 50ms. and the parking

lights will flash once every time the button

or is pressed.

4. Press button

and to save the settings you have entered. The parking lights will

flash 5 times.

5. Release the brake pedal – the time delay programming is now complete.

Tach Learning

Tach jumper settings

Some new vehicles have a higher

TACH voltage threshold, which

would fall out of the normal TACH

trigger circuit of the remote car

starter. Changing the jumper to

TACH Threshold HIGH will allow the

module to properly detect the TACH

signal.

Multi-speed Tach Programming Procedure

The system is designed to read a wide range of Tach signals produced by newer Ignition

systems. Note that you should go through the Tach programming procedure every time a new

Unit is installed.

1. Enter programming mode (page-16)  the parking lights will stay on for up to 20

seconds.

2. Before the lights go out, press and hold the brake pedal and press

and

simultaneously  the parking lights will flash 4 times.

3. Release the brake pedal.

4. Start up the engine and allow the vehicle to reach regular engine idle speed.

5. Once the engine is running at normal idle speed, press the brake pedal and keep it

down until you hear the parking lights output click 5 times.

6. Release the brake pedal the tach programming is now complete.

Note: If another Tach programming is required, simply repeat the “Multi Speed Tach

learning”.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Sin comentarios

ProStart CT-3271 Guía de instalación Pagina 18